Search results for: '308 20 200'
Did you mean 300 20 200?
- Did you mean
- 300 20 200
- 30 20 200
- Related search terms
- 200
- 200 0
- 200 0.5
- 200 02 300
- 200 02 308
-
Adapter pipe DN 40for flange pumps DN 40 DN 40 x 30 mm
Installation length from 220 to 250 mm Learn MoreOur offer is exclusively aimed at corporate clients.
-
Adapter piece DN 50for flange pumps DN 50 DN 50 x 30 mm
Installation length from 250 to 280 mm Learn MoreOur offer is exclusively aimed at corporate clients.
-
Stainless-steel corrugated hose SolarflexIdeal for the roof part leading to the collector. Learn MoreOur offer is exclusively aimed at corporate clients.
-
2-way zone valveCan be used in solar and heating installations as a zone valve, which means that single parts of the system can be connected or disconnected.
The actuator is equipped with a relay which is actuated by a 2-point signal, if need be it can also be manually operated.
The 2-way zone valve can be operated in both directions. Learn MoreOur offer is exclusively aimed at corporate clients.
-
System separation DN 25 (1") for HeatBloC®sFunction:
Separation of the boiler circuit and the consumer circuit
Field of application:
for radiant panel heating systems with plastic pipes for the protection of new boilers in older heating installations
Recommended application range:
Min. residual head: 1.5 m
Temperature difference primary: 60-50 °C
Temperature difference secondary: 35-45 °C
Range of performance:
depending on the pump of the heating circuit used and the amount of plates of the heat exchanger
16 plates: up to 20 kW, 10 K up to 1720 l/h
30 plates: up to 23 kW, 10 K up to 2010 l/h
40 plates: up to 25 kW, 10 K up to 2150 l/h Learn MoreOur offer is exclusively aimed at corporate clients.
-
2-way zone valve DN 20for connecting and disconnecting single storage tanks,
DN 20, ¾" int. thread,
setting time for 90°: 30 sec. Learn MoreOur offer is exclusively aimed at corporate clients.
-
2-way zone valve DN 25/32for connecting and disconnecting single storage tanks,
DN 25, 1" int. thread, setting time for 90°: 30 sec.
DN 32, 1¼" internal thread, setting time 90°: 30 s Learn MoreOur offer is exclusively aimed at corporate clients.
-
Immersion sleeves ½" ext. threadfor the installation of the temperature sensors (d = 6 mm) in the storage tank, in the collector and the hydraulic separator.
Attention: suitable for ball valves until 2016!
566001: self-sealing with, o-ring, polished brass, for sensor, T = 30 mm
566002: standard, chromed brass, for sensor, T = 60 mm
5660021: standard, chromed brass, with valve extension (25 mm), for sensor, T = 60 mm
566003: standard, chromed copper, for sensor, T = 100 mm
566004: standard, chromed copper, for sensor, T = 150 mm Learn MoreOur offer is exclusively aimed at corporate clients.
