Search results for: 'gt 230 2150'
Did you mean gt 230 21.0?
- Did you mean
- gt 230x 2156x
- gt 230x 2157x
- Related search terms
- 2150
- 2150 0
- 2150 02 30
- 2150 02 35
- 2150 02 32
-
Ball stop (PKS)1 x PAW flange (without nut)
1 x internal thread
Material: brass
With automatic air passage and check valve (can be opened),
with red butterfly handle Learn MoreOur offer is exclusively aimed at corporate clients.
-
Adapter pipe DN 40for flange pumps DN 40 DN 40 x 30 mm
Installation length from 220 to 250 mm Learn MoreOur offer is exclusively aimed at corporate clients.
-
Adapter piece DN 50for flange pumps DN 50 DN 50 x 30 mm
Installation length from 250 to 280 mm Learn MoreOur offer is exclusively aimed at corporate clients.
-
System separation DN 25 (1") for HeatBloC®sFunction:
Separation of the boiler circuit and the consumer circuit
Field of application:
for radiant panel heating systems with plastic pipes for the protection of new boilers in older heating installations
Recommended application range:
Min. residual head: 1.5 m
Temperature difference primary: 60-50 °C
Temperature difference secondary: 35-45 °C
Range of performance:
depending on the pump of the heating circuit used and the amount of plates of the heat exchanger
16 plates: up to 20 kW, 10 K up to 1720 l/h
30 plates: up to 23 kW, 10 K up to 2010 l/h
40 plates: up to 25 kW, 10 K up to 2150 l/h Learn MoreOur offer is exclusively aimed at corporate clients.
-
Solar check valve RSS DN 20with brass valve plate,
all installation positions possible,
opening pressure 200 mm wc,
¾" internal thread,
length = 50 mm
1211: can be opened, up to 150 °C
12111: without possibility for manual opening, up to 220 °C Learn MoreOur offer is exclusively aimed at corporate clients.
-
Reducer set DN 50 - DN 402 reducing flanges made of zinced steel for connecting a DN 40 HeatBloC® on a DN 50 modular distribution manifold. For the assembly of a DN 40 pump, installation length 250 mm, in a DN 50 HeatBloC®.
One side DN 50 flange (PN 6), other side DN 40 flange (PN 6). Reduction of the centre distance from 180 mm to 160 mm, with seals and screws, installation height = 13 mm
Use only with slip-on flanges!
Learn MoreOur offer is exclusively aimed at corporate clients.
-
Immersion sleeves ½" ext. threadfor the installation of the temperature sensors (d = 6 mm) in the storage tank, in the collector and the hydraulic separator.
Attention: suitable for ball valves until 2016!
566001: self-sealing with, o-ring, polished brass, for sensor, T = 30 mm
566002: standard, chromed brass, for sensor, T = 60 mm
5660021: standard, chromed brass, with valve extension (25 mm), for sensor, T = 60 mm
566003: standard, chromed copper, for sensor, T = 100 mm
566004: standard, chromed copper, for sensor, T = 150 mm Learn MoreOur offer is exclusively aimed at corporate clients.
